Ubuntu-Server 6.10 防火墙系统安装

　　Have Fun!

　　First, do a clean install using Ubuntu-Server 6.10. During installation, proper settings for eth0 will be detected automatically. If this fails, change your network cables and try again. There is a very small chance that your ISP does not run a DHCP server (never seen that happen), or it just might be down (seen that quite a few times, also they may screw up their DNS every now and then), in which case you are on your one, best to wait till they are done fixing it.

　　So we start out with a DHCP assigned address for eth0. This is just an easy way to figure out which NIC is actually eth0. If you already know which is which you better start out with a static address for eth0. If your ISP isn't crappy, you have the proper settings for it.

　　Now proceed and accept all defaults (but you may want to do your own partitioning) At the end of the process you will be asked if you want to install extra packages. Select "LAMP" and finish.

　　Now login as the new user you just made and do:

　　sudo passwd

　　Now enter your password again. Next enter the new password for user "root" and confirm. So we dropped the nasty sudo experience (bit strange on a server, isn’t it?) Now logout and login again as root with the new root password.

　　Do:

　　apt-get install vim

　　Using vim (or your favorite editor) edit /etc/apt/sources.list Comment out the cd repository. Next add "universe" (without the quotes) to all lines that aren't commented out. Save the file.