Cisco 6000 MSFC口令的恢复

　　Contents

　　Description

　　Step-by-Step Procedure

　　Example of a Password Recovery on the Catalyst 6000 MSFC Module

　　Related Information

　　Description

　　This document describes the password recovery procedure for the Cisco Catalyst 6000 Multilayer Switch Feature Card (MSFC).

　　Step-by-Step Procedure

　　Attach a terminal or PC with terminal emulation to the console port of the switch.

　　Use the following terminal settings: 9600 baud, no parity, 8 data bits, 1 stop bit

　　Type show module to determine the MSFC card on which to do password recovery.

　　The MSFC module is in slot 15 or 16.

　　Reset the MSFC module you want to do password recovery on.

　　Use the reset command to do this.

　　Wait 5 seconds and then connect to the MSFC console using the switch console command.

　　After seeing the message "Connected to Router", issue a break sequence.

　　The break key is a unique sequence that will break the MSFC into rommon. If this does not work, please refer to the break sequence page.

　　The MSFC will boot to a rommon> prompt.

　　Type confreg 0x42 at the rommon> prompt to configure the MSFC to boot without its configuration.

　　Display the current software in bootflash by issuing the dir bootflash: command and record the current software version.

　　Boot the system with the boot bootflash: command.